9,000 Watts! Thank you so much to Joe Harvey of RiVr (www.rivr.com) for the edit! Please visit their website to see the amazing work that they do!!.. And also thank you to Keith Walpole for piloting the drop-drone and helping make the flight a success! I must also thank APD Power drives (www.powerdrives.net) for their astonishing ESC. It weighs under 50g and can take over 10kw! Their customer service is the best I have ever experienced after a failure that was my fault. This project would not have been possible without their incredible ESC. Thank you Jeremy for your amazing service. Speed is shown on the OSD and is measured with a 10hz GPS. It is a ground speed measurement.
Specs are: VASA Model 'Fusion' (http://www.vasamodel-eshop.cz/en/e/modely-3/jety-19/fusion-21/) ESC: APD F200a (https://shop.powerdrives.net/) Battery: 4s+4s+4s+2s in series to make 14s 58.8v. Tattu 'R' line 2,000mah 120c cells. Servos: KST X010 in a 3d printed frame. Motor: High End Technology Typhoon 700-83 39mm in-runner with an 8mm shaft. Propeller: Dr.Ralph Okon (Powercrocco) manufactured by Marcus Koch Custom folding prop yoke with 7075 aluminium yoke, steel collet and titanium locknut. OSD: MyFly Dream Telefly OSD. Video: 1.3ghz Partom VTX. (Banggood.com) Control RX: EZUHF. (a previous time in history lol) Antennas: 433mhz Dipole and 1280mhz inverted 'v' antenna. (Prodrone.pl) Cameras: Runcam swift mini for FPV. Runcam 'Spilt-Mini' for HD. (runcam.com) Information on the plane and some of the build techniques used can be found here: https://www.rcgroups.com/forums/showthread.php?3567001-VASA-Fusion
